Areation Systems

The Aquastrip panels are membrane-type fine bubble air diffusers for aeration processes of activated sludge treatment plants. The panel diffusers are large surface units fixed directly on the bottom of the tank, consisting of a support frame in AISI 316Ti or PVC, on which a 0.6 mm thick polyurethane (PU) membrane is stretched and microperforated with 400,000 holes per square meter, chemically inert and designed to last. High coverage provides a particularly low specific air flow, allowing the production of very fine and uniformly distributed bubbles with consequent high efficiency of oxygen transfer. The peculiarities of the system make it perfectly suitable for use in intermittent aeration processes.

Model Q

Fine bubble diffusers model Q; Body: PVC; Membrane: PU; Connection: DA32 connection; Width: 0.18 m; Length: from 1 to 4m spaced 0.5m; Height: 5 cm; EU Membrane: 10-80 Nm3 / h / m2; LP Membrane: up to 120 Nm3 / h / m2

Contact Us

  • null
    Flowrate: 120 Nm3/h
  • null
    Temp. Max refluo: 35°C
  • null
    Pressure Max: 110 mbar

Model T

Model T; Body: AISI 316Ti; Membrane: PU; Connection: 1” gasm connection; Width: 0.18 m; Length: from 1 to 4m spaced 0.5m; Height: 2 cm; EU Membrane: 10-80 Nm3 / h / m2; LP Membrane: up to 120 Nm3 / h / m2

Contact Us

  • null
    Flowrate Max: 120 Nm3/h
  • null
    Temp. Max refluo: 35°C
  • null
    Pressure Max: 110 mbar

Model G

Groups of 3,4 or 5 model Q diffusers pre-assembled on “U” profiles in AISI 304. They allow to reach the bottom cover even over 50% of the available surface and simplify the installation.

Contact Us

  • null
    Flowrate Max: 600 Nm3/h
  • null
    Temp. Max refluo: 35°C
  • null
    Pressure Max: 110 mbar

Model E

Groups of 3,4 or 5 model T pre-assembled on “U” profiles in AISI 304. They allow to reach the bottom cover even over 50% of the available surface and simplify the installation.

Contact Us

  • null
    Flowrate Max: 600 Nm3/h
  • null
    Temp. Max refluo: 35°C
  • null
    Pressure Max: 110 mbar

Removable Systems

To avoid tank emptying during the control / maintenance operations, it is possible to install the diffusers (both Q and T models) on extractable structures made of AISI 304. In some cases it is also possible to insert them in a full tank during the first installation, in the most common cases, however, the first installation must take place with an empty tank.

Contact Us

  • null
    Flowrate Max: n.a.
  • null
    Temp. Max refluo: 35°C
  • null
    Pressure Max: 110 mbar